Floor Painting Tips and Guidelines

As time goes by people often get bored of the looks of their wooden floors. You can go a step beyond the usual move of removing and replacing your old wood floors by repainting them instead. This will take less effort than dealing with the other solutions, but you will have to be properly prepared if you want to make things work.
Decide on the colors
Before you make your move you will need to be fully aware of the type of color you want, or maybe even colors if you want to avoid a monotonous look. Do keep in mind that the colors you choose will have a great impact on the rest of your décor, so you will need to keep them balanced with the rest of the room. Also you will need to ensure that the colors you choose will complement each other and not stand out far too much.
Cleaning and sanding phase
Once you figured out which colors you want to use, you will need to get the floor ready for your paint job. Begin by cleaning and sweeping your floor, as well as removing and dealing with carpet cleaning, upholstery cleaning and so on, emptying the room from all furniture so you can work on it. Dealing with this and sanding the floor once you’re done cleaning will ensure you have a nice, smooth floor to work with once you’re done. Make sure you clean the floor from all traces of wood dust before you move on to painting, or else the paint won’t adhere quite as well.
Area preparation
Once you’ve finished sanding your floor, as well as cleaning it, you will need to work on preparing the area. This will mean you need to protect anything that may end up being stained during the painting procedures. A good example of that would be to cover and tape off any power outlets, trimming and other areas that need to be kept clean.
Lay on the base coat
Whenever you figure you want to paint a floor, you will need to begin with the base coat. It will need to work as the base, the blank canvas you build on as you keep working forward. When you do so, you will need to start from the exterior, working your way in. Use a roller for the larger areas and a brush for the exterior as you will need to be more precise. Let the paint dry and sand any rough patches that need work when it’s completely dry. Once that is complete you will need to lay on another coat to complete this part of the job.


Taping the pattern
With a rough pattern made on the floor, you will then have a chance to work on the actual paint job. The best way you can do this is by simply laying on some painting tape for the design you want to have. Be careful to keep the design as close as possible to what you have in mind, using a razor blade to round out edges and so forth if you want to make such an interesting approach work well. Make sure you work lightly with the blade, as you may end up slicing into the floor if you’re not careful.
Painting the first coat
You need to start painting the design and the rest of your floor, but you need to make sure you stay within the line so you won’t have to do too much touch up work. Make sure you also allow each coat to dry completely before you apply the new one.
Repeating and inspecting your work
Take a good, long look at your dried floor and see whether there are any areas you will need to work on again. Once you have that done you will need to apply the secondary coat, repeating the steps if you must.
Removing the tape
Once you’re done with the paint, you will need to see about removing the tape you used for the areas that needed to be protected. This will allow you to deal with the areas in question, but make sure you do this carefully and possibly without allowing too much movement as this may hurt your work.
Finishing touches
All of painting requires careful work, so you would do well to stay within the line and help protect the work you’ve done. The best way to seal it all in is to use the proper sealant, making the wear and tear on your newly painted floors more manageable. For more ideas: Eco-friendly Carpet Cleaning in Bow

About Heather

Leave a Reply

Your email address will not be published. Required fields are marked *